Rubbee 3.0 - Electric bike motor kit

If you need a kit easy to assemble, it can be used on any bike, share it with others, or to put it and remove in seconds, your electric motor kit bike is Rubbee. Rubbee drive is a unique product for the market of electric bicycles. This one-piece system containing batteries, electronics and a motor. It can be attached to one's bicycle in only a matter of seconds without using any tools.

The use of latest solutions in battery and electric motor technologies allows this system to be lightweight and very efficient in using the stored power. High efficiency controller and a custom electric motor increase the range while the high capacity batteries keep the weight down and make the system easy to carry around. Innovative engineering solutions increase the grip of the friction wheel and make the whole system detachable in less than 30 seconds. It requires no special training to be used in its full potential, no messy wiring and difficult to understand assembly drawings. Rubbee is probably the easiest to use electric bicycle conversion kit in the world.

Hold the Rubee to the seat post with the quick release and lay it on the rear wheel. Its engine of 250W power turns the small wheel which spins the wheel of the bicycle. The strong support and intelligent motor control prevents slipping and thus no wear occurs on the roller or the bicycle tire. The unit shock absorver allows you to use it in full suspension bikes without any problem, allowing free movement of the suspension without losing the driving force of the engine. You can uphill easily and effortlessly.

Two easy installation PAS sensors are included to have prepared two bikes. These sensors detect when you are pedaling and the rate at which it is made. Depending on the rate of pedaling and of the wheel speed, the system intelligently decides the required level of assistance. As required by law, if the user stops pedaling Rubbee stops pushing, and also is limited to 25km / h.

A throttle is available on request (30 €) for use on private roads without pedaling sensors. You can also buy more PAS sensors and chargers.

Compatibility:

Wheel Diameter: 16 to 29 inches.

Wheel thickness: 20mm to 60mm.

Compatible with suspension systems: Yes

Seatpost diameter: 22mm to 35mm.

Bottom Bracket: square drive and Hollowtech.

Rubbee 3.0 Technical characteristics:

Autonomy: 40 km / 25 miles

Speed: 25 km / h / 16 mph (limited by law)

Power: 250 W

Full-charge time: 4 hours.

Charging time 80%: 2 hours.

Weight: 6.8 kg / 15lbs

Charger: 90-295 V 47-63 Hz 145 W

Battery: 14.4 V 20 Wh 280 Ah LiFePO4

Battery life: over 2000 charge cycles.

Ambient temperature: -5 to 35 ° C, with overheat sensor to low power if it detects overheating.

Weatherproof (but not waterproof).

Dimensions: 160-410-120 mm / 6.2-16.1-4.7 in

Made in Europe with the highest standards of quality and meeting all European standards. Including: FCC, WEEE, IP55, EN15194, CE, ...

2-year warranty.