Catalog
The specific ebike Vittoria eMazza tyre to practice Enduro with your 27.5 Plus ebike. The Vittoria eMazza give you all the grip with the four compounds used. Reinforced carcass with high protection against punctures and cuts. Available in 27.5x2.60.
Seal for the inner needle bearing of the crankshaft of the Brose motor. This seal help to protect your motor from water ingress. To install it you need to open the motor and extract the needle bearing. The seal is fitted before the bearing with the lip facing outwards.
Special grease that MUST be used in the sprag clutch bearings of the Brose motor. Sprag clutch bearings allow rotation of a shaft in one direction but not the other. These bearings require lubrication to work reliably, but also rely on friction when they are required to stop rotation, so you can't use Teflon or ceramic based greases made to slip. Small pot but enough for both bearings. 5ml.
Bafang M500 white plastic gear assembly for ebike motors. Includes the white nylon gear, the center steel spindle and the bearings, all ready to be mounted.
Bafang M510 white plastic gear assembly for ebike motors. Includes the white nylon gear, the center steel spindle and the bearings, all ready to be mounted.
Bafang M300 white plastic gear assembly for ebike motors. Includes the white nylon gear, the center steel spindle and the bearings, all ready to be mounted.
Gasket for Bafang M300 / M420 / M500 / M510 ebike motors. With this Bafang motor gasket you will be able to reseal the motor after doing maintenance. Price per unit.
Select your Bafang motor model.
Shimano EP8 drive unit cover to protect the lower part of the EP800 & EP801 ebike motors. Made of plastic. Shimano original design (could be different that the original model of the bike).
Bosch Gen4 Performance Line CX logo round cover replacement for Bosch bicycle motors. Diameter: 5,6cm.
Light cable with the needed connector for Yamaha and Giant motors. Now you can connect your front or rear light directly to your motor to get energy from the main battery.
The RockStop ebike frameguard is a rubber frame protector that resist the worst stone impacts to the frame. The form and the internal aluminium plate of this protector let it adapt to any frame including that with a curved tube. More width to fit ebike frames. Easy install without tools.