Brose There are 34 products.

• 

  10,90 €

  Bosch, Brose and ISIS M15 crank bolts

  M15 allen bolts for Bosch Gen2 & Gen4 (Active, Performance, Performance CX), Brose and ISIS cranks. Autoextract system for cranks with 21mm threaded hole. Price per Pair of bolts.

  10,90 €
• 

  75,90 €

  Bearing race for Brose C, T, TF, S & S-Mag belt pulley sprag bearing.

  Bearing race for belt pulley sprag bearing in Brose C, T, TF, S & S-Mag ebike motors. Price per unit.

  75,90 €
• 

  79,90 €

  4 in 1 press tool for Brose ebike motors

  This is a solid stainless steel press tool designed to complete 4 of the more awkward press jobs that are encountered when overhauling a Brose motor C, T, S & S-Mag. View below an extended description.

  79,90 €
• 

  41,90 €

  Brose motor wire for HIGO type displays 5 pins

  Brose motor wire to connect HIGO type displays. Compartible to the Marquardt JD3 and to ZEG Bikes from 2018, and the new style Brose All round Display. 1300 mm long.

  The motor conector has 5 pins with the 5 wires connected. We have other version with the motor conector with 4 pins & wires conected, and an independent wire (4+1).

  41,90 €
• 

  195,90 €

  Display Brose Marquardt

  The Brose Marquardt Display for ebikes with Brose motors is practical and distinctive in design. The 1.5-inch color display is easy to read. The display can be installed on the right or left and is therefore the stylish all-in-one solution per excellence.

  NOTE: you need the correct wire to connect this display with your Brose motor (not included).

  NOTE: Not work with Specialized or BH bikes.

  195,90 €
• 

  15,90 €

  Brose lock ring for chainring

  Brose lock ring for chainring. Replacement needed if you worn or damaged the original lock ring of your Brose ebike electric motor.

  15,90 €
• 

  3,95 €

  Unused sockets blanking plug for Brose motors

  With this plug you can seal the unused ports that you do not use in your Brose motor bike to avoid getting dirty or damaged. Price per unit.

  3,95 €
• 

  6,90 €

  Brose X-ring seals (pair)

  X-ring seals to increase protection of Brose motors.  Fit an external X-ring seal each side of the crankshaft to further stop the chance of any water ingress into the Brose motor. Price per pair of seals.

  6,90 €
• 

  10,95 €

  Seal for the needle bearing of the crankshaft of the Brose motor

  Seal for the inner needle bearing of the crankshaft of the Brose motor. This seal help to protect your motor from water ingress. To install it you need to open the motor and extract the needle bearing. The seal is fitted before the bearing with the lip facing outwards.

  10,95 €
• 

  5,50 €

  Sprag clutch bearing grease for Brose motors 5ml

  Special grease that MUST be used in the sprag clutch bearings of the Brose motor. Sprag clutch bearings allow rotation of a shaft in one direction but not the other. These bearings require lubrication to work reliably, but also rely on friction when they are required to stop rotation, so you can't use Teflon or ceramic based greases made to slip. Small pot but enough for both bearings. 5ml.

  5,50 €